Ara
Toplam kayıt 21, listelenen: 11-20
The Fractographic Investigation of an Aeroengine Accessory Gearbox Quill Shaft
(De Gruyter, 2020)
This paper analyzes the fracture of the quill shaft. An investigation of a twin-engine trainer aircraft incident has been reported. The incident occurred due to the right electric generator out and low oil pressure. The ...
The Research of the Delamination Formation Regarding Pressure Change in Cutting With Abrasive Water Jet (AWJ) For Carbon Fiber Reinforced Polymer (CFRP) Materials
(İksad Publishing House, 2021)
The Abrasive Water Jet (AWJ) cutting has a wide range of usage in many areas of technology, especially
in the aviation industry. The mentioned process is realized by spraying the 100-200 µ size abrasive
particles on the ...
Usage of Additive Manufacturing and Topology Optimization Process for Weight Reduction Studies in the Aviation Industry
(ASTES Publishers, 2021)
The Additive Manufacturing (AM) technology is a disruptive and novel technique that
changes the paradigm of manufacturing methodology. It is based on the principle of having
3D parts by adding simple 2D layers on and on. ...
The Novel Manufacturing Techniques of the Airborne Parts
(Gece Kitaplığı, 2020)
Introduction - Aviation is a well-regulated industry. The rules and regulations
are well defined and the borders are bolt between the functions. The
International Civil Aviation Organization (ICAO) is a top airworthine ...
The Adverse Effects of Implementation of the Novel Systems in the Aviation Industry in Pursuit of Maneuvering Characteristics Augmentation System (MCAS)
(Innovare Academics Sciences Pvt. Ltd, 2020)
In the aviation history, there are many remarkable accidents. But rare of them are close to each
other with the same types of aircraft. Basically, incidents are categorized as the Controlled Flight into the
Terrain (CFIT) ...
The Implementation of Additive Manufacturing Technologies in Aircraft Maintenance, Repair, And Overhaul (MRO) Operations
(İksad Publishing House, 2021)
Chip-away technologies are traditional manufacturing methods based on the principle of taking-out particles
from a large workpiece employing cutting tools. Its origins date back centuries. On the other hand, Additive
M ...
The Temperature and Material Distribution Inside a Gas Turbine Engine
(Crimson Publishers, 2022)
The propulsion for the air vehicles is generated by the power obtained from the engines.
Especially during take-off and climb phases, the air vehicles need the maximum power.
Mainly, as presented in Figure 1, it is ...
Failure analysis of J85-CAN-15 turbojet engine compressor disc
(PERGAMON-ELSEVIER SCIENCE LTD, THE BOULEVARD, LANGFORD LANE, KIDLINGTON, OXFORD OX5 1GB, ENGLAND, 2021)
This paper analyzes the J85-CAN-15 engine damage due to fracture of the compressor disc 8th
stage dovetail post. An Inner Object Damage (IOD) phenomenon was identified. The damaged
compressor disc material is Incoloy 901 ...
Fracture and Failure Analysis of the Trainer Aircraft Rudder Pedal Hanger
(ELSEVIER SCI LTD, THE BOULEVARD, LANGFORD LANE, KIDLINGTON, OXFORD OX5 1GB, OXON, ENGLAND, 2021)
This study analyzes the T-38A Talon twin-jet trainer aircraft rudder pedal hanger damage due to
the fracture that has been identified at the clevis surfaces where the tension rises. The hanger has
the function of swinging ...
A Methodological Research on the Correlation between the Airborne Part Manufacturing System and Aircraft Maintenance Operations
(Alpha Publishers, 2020)
Aviation is one of the high value-added and well-regulated industry. During
the design and manufacturing phase, the aircraft manufacturing companies
are focusing on the follow-on-support stage. A commercial aircraft's
lifespan ...